JustSomeDude
Sun Aug 10th, 2008, 03:32 PM
So, I was experiencing some fierce vibration as of late when applying moderate to hard braking pressure (ie, quick and/or hard stops). I called Erico since the bike was still under warranty, and they gave me this rigmarole about "check for glazing, etc.". I figured they were just trying to get out of checking the torques on the steering stem, forks, etc.
Well, lo and behold, I pull the pads this morning, and they are glazed over to all GET OUT....
http://pixpipeline.com/st/ed7207b7937a.jpg (http://pixpipeline.com/d/ed7207b7937a.jpg) http://pixpipeline.com/st/3f05e92c01de.jpg (http://pixpipeline.com/d/3f05e92c01de.jpg)
Any tips for removing this shit? Grit of sand paper? Belt sander or just hand pressure? Any advice would be greatly appreciated!! :)
Well, lo and behold, I pull the pads this morning, and they are glazed over to all GET OUT....
http://pixpipeline.com/st/ed7207b7937a.jpg (http://pixpipeline.com/d/ed7207b7937a.jpg) http://pixpipeline.com/st/3f05e92c01de.jpg (http://pixpipeline.com/d/3f05e92c01de.jpg)
Any tips for removing this shit? Grit of sand paper? Belt sander or just hand pressure? Any advice would be greatly appreciated!! :)