PDA

View Full Version : 03 CBR600RR wont start?



zehster
Sun Aug 28th, 2011, 08:26 PM
How do I jumper out the 4 wire plug to see my MIL code?

The fuel pump wont start up when I turn the bike on and I've jumpered out the fuel pump and can get it to run and pump fuel out. Also i've checked the relay's and tip sensors, all check out good. Any Idea's?

ImortalUK
Sun Aug 28th, 2011, 08:49 PM
Is light flashing?

ImortalUK
Sun Aug 28th, 2011, 08:55 PM
And does the 03 have the transponder key?

ImortalUK
Sun Aug 28th, 2011, 09:20 PM
According to my manual (2003/2004):
A long blink = "10"
A short blink = "1"
DNS = Engine does not start
EON = Engine operates normally

And I quote (i.e. don't shoot the messenger):

BLINKS : PROBLEM, SYMPTOMS
No blinks: ECM malfunction, DNS
No blinks: ECM power / ground circuit malfunction, DNS
No blinks: ECM output line malfunction, DNS
No blinks: MIL circuit malfunction, EON
Stays lit: Data link circuit malfunction, EON
1 blink: MAP sensor circuit malfunction, EON
2 blinks: MAP sensor performance problem, EON
7 blinks: ECT sensor circuit malfunction, Hard start at low temp
8 blinks: TP sensor circuit malfunction, Poor performance on quick throttle operation
9 blinks: IAT sensor circuit malfunction, EON
11 blinks: Vehicle speed sensor circuit malfunction, EON
12 blinks: No. 1 Primary injector malfunction, DNS
13 blinks: No. 2 Primary injector malfunction, DNS
14 blinks: No. 3 Primary injector malfunction, DNS
15 blinks: No. 4 Primary injector malfunction, DNS
16 blinks: No. 1 Secondary injector malfunction, DNS
17 blinks: No. 2 Secondary injector malfunction, DNS
18 blinks: Cam pulse generator, no signal, DNS
19 blinks: Ignition pulse generator, no signal, DNS
21 blinks: No. 1 O2 sensor circuit malfunction (California only) , EON
22 blinks: No. 2 O2 sensor circuit malfunction (California only), EON
23 blinks: No. 1 O2 sensor heater malfunction (California only), EON
24 blinks: No. 2 O2 sensor heater malfunction (California only), EON
33 blinks: E2-PROM in ECM malfunction, EON
48 blinks: No. 3 Secondary injector malfunction, DNS
49 blinks: No. 4 Secondary injector malfunction , DNS

ImortalUK
Sun Aug 28th, 2011, 09:26 PM
Should be a 2 wire connect under seat . Wires if I remember are yellow. Yellow/white

zehster
Mon Aug 29th, 2011, 04:49 AM
The light doesn't flash at all. I have the manual and it says that the 4 wire plug is the service port and u need to jumper two of the wires. Problem is they tell you to use a special tool that does that for you. But doesn't tell you witch wires you need to jumper.

ImortalUK
Mon Aug 29th, 2011, 07:25 AM
There should be a 2 wire conecter back right under rider seat? All run simp buy techs and see if I can get u an idea what's going on

The_Jackel
Mon Aug 29th, 2011, 09:14 AM
http://www.cosportbikeclub.org/forums/http://i240.photobucket.com/albums/ff181/Jackelmotorsports/600rrcodes.jpg

This is for the 03-04 600RR

ImortalUK
Mon Aug 29th, 2011, 09:42 AM
Perfect pic

ImortalUK
Mon Aug 29th, 2011, 09:47 AM
How do I jumper out the 4 wire plug to see my MIL code?

The fuel pump wont start up when I turn the bike on and I've jumpered out the fuel pump and can get it to run and pump fuel out. Also i've checked the relay's and tip sensors, all check out good. Any Idea's?

Will the motor turn (but will not fire)

The_Jackel
Mon Aug 29th, 2011, 11:54 AM
The engine turns but will not fire? But it will fire when you jump the fuel pump? If so you need to check the fuel "cut" relay that powers the pump.

zehster
Mon Aug 29th, 2011, 08:29 PM
http://www.cosportbikeclub.org/forums/http://i240.photobucket.com/albums/ff181/Jackelmotorsports/600rrcodes.jpg

This is for the 03-04 600RR

I've got that manual page, but I don't have that connector that jumpers the wires. I wish I new what wires they want me to jumper with out the tool.


The motor turns over but doesn't fire up at all or even close. I will try jumpering the wires to the full pump and see if I can get the bike to start that way.

ImortalUK
Mon Aug 29th, 2011, 08:40 PM
Ok one more when u are trying to start does the headlight shut off?

ImortalUK
Mon Aug 29th, 2011, 08:43 PM
Should be a triangle. O. O
OOO. Oxx.

ImortalUK
Mon Aug 29th, 2011, 08:45 PM
3 wires side by side 1 on top. Middle to right

zehster
Tue Aug 30th, 2011, 04:05 PM
Ok one more when u are trying to start does the headlight shut off?

When I hold the button the head light shuts off. But as soon as I stop trying to start the bike, the light comes back on.

zehster
Tue Aug 30th, 2011, 04:05 PM
3 wires side by side 1 on top. Middle to right

Um I don't get what your trying to tell me with this, sorry.

ImortalUK
Tue Aug 30th, 2011, 04:10 PM
Trying diag ur prob with out touching or feeling the bike

ImortalUK
Tue Aug 30th, 2011, 04:11 PM
that's what wires to jumper