Looking to do some testing on the sprocket sizes this week. I have the 03 R6 manual and it just says remove the bolt and washer on the outside of the sprocket, and gives torque spec for putting it back on. Is there any tricks? Do I just use a large socket and give it a turn? Any special tools or tips I need to know before I dive in this evening?
Also what size is the bolt that holds the sprocket on for the 03R6.....Its bigger than any sockets I have so Im gonna need to buy it.
Also I noticed my teeth were a bit worn on the front sprockt after PPIR. I believe my chain tention is a bit off. What is a good point of reference for chain tention. 1/4 + or - inch movement....yada yada?
Thanks for any suggestions and advice
D