Hey Krod- What were those brake pads you had on your drz? I need a new set and would like to get the same ones. Oh, and I got the back end slidin. It was a lot of fun, but I could never hit the apex while sliding.
Hey Krod- What were those brake pads you had on your drz? I need a new set and would like to get the same ones. Oh, and I got the back end slidin. It was a lot of fun, but I could never hit the apex while sliding.
EBC sintered from Performance cycle.
Heard they tear up the rotor... you have any problems with them? They're sure cheaper than the oem ones eddie recommends.
I liked the OEMs better than the HH's I put on my DRZ, took 'em off and put the OEM's back on. I am running MotoMaster Hards on the KTM and YZ. Personally I don't worry too much about rotor wear, never had a bike long enough for it to show up.
Ok, so I just read the 07 RM Supermoto rules and they require peg sliders as well... where did you guys get yours? I can't find any that fit a DR-Z
http://www.supermotoengineering.com/...ail.php?id=185
http://www.motostrano.com/supegsl.html
Just have to make em work, I have the UFO's and they suck, I am going with weld ons next