Results 1 to 4 of 4

Thread: What would happen if your chain adjuster thingie fell off? Kawi 650R.

  1. #1
    Senior Member sky_blue's Avatar
    Join Date
    Dec 2006
    Location
    FTC
    Posts
    736

    What would happen if your chain adjuster thingie fell off? Kawi 650R.

    Theoretically. Lets say the right chain adjuster of your Kawasaki 650R fell off. What could possibly happen? Lets say the stuff circled in red is missing:



    Ideas of how this might affect the handling of the bike? Cause a high side? Low side?


  2. #2
    Douche Yearly Supporter Sortarican's Avatar
    Join Date
    Jun 2006
    Location
    LiDo
    Posts
    8,375

    Re: What would happen if your chain adjuster thingie fell off? Kawi 650R.

    I lost one side once, not sure how long I ran on it, noticed it when it started wobbling the rear end.
    The axle started creaping forward on the missing side and missaligned the wheel.
    It wore the tire pretty badly but didn't cause a crash or anything.
    It was on a cruiser so I wasn't pushing it too hard in the turns.
    Last edited by Sortarican; Tue Jun 3rd, 2008 at 11:26 AM.
    Be assured that a walk through the ocean of most souls would scarcely get your feet wet.

  3. #3
    Gold Member Yearly Supporter McVaaahhh's Avatar
    Join Date
    May 2004
    Location
    Tucson
    Posts
    5,100

    Re: What would happen if your chain adjuster thingie fell off? Kawi 650R.

    Um, I'd fix that ASAP!
    '02 RC-51 - Street
    '05 Pitster Pro 125 - Pitbike madness

    Be polite. Be professional. But be prepared to kill everyone you meet.

    "Motorcycles tell us a more useful truth: we are small and exposed, and probably moving too fast for our own good, but that's no reason not to enjoy every minute of the ride."
    ~Dave Karlotski

  4. #4
    Only here for the free Wi-Fi Site Admin Spiderman's Avatar
    Join Date
    Aug 2000
    Location
    Wheat Ridge
    Posts
    8,471

    Re: What would happen if your chain adjuster thingie fell off? Kawi 650R.

    I'm not sure, but I think/believe: (<-- that, right there, is my disclaimer!)

    If the axle is tight within the swingarm, it shouldn't cause an immediate problem, but it would move eventually (as Jeff mentioned: "creeping"). Unless you didn't notice the wobble, and probable bad handling, I don't suspect that it would cause a highside or lowside. It might turn more easily in one direction, and more difficultly in the other. If the axle isn't straight, you're also putting added stress and wear on your chain & sprocket.

    If it's your only mode of transportation, I'd ride it as little as possible - preferably only to the nearest dealer to get replacement parts installed.
    Bob <------ Asshole Nazi devil moderator out to get each and every one of you
         - 2002 Yamaha R1 (92K+ miles... bought new) ---------------------------------------->
         - 2015 Yamaha Bolt C-Spec (Cafe Racer)
         - 2004 Yamaha R6 (racebike)
         - 2006 Yamaha R1 (racebike)
    R.I.P. 502
    ~ Everything works out in the end. If it hasn't worked out, it isn't the end.

Similar Threads

  1. 06 R6 chain adjuster fit 03-05 ?
    By BlueDevil in forum Bike Tech
    Replies: 4
    Last Post: Wed Mar 22nd, 2006, 07:05 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •