anyone find out in the middle of installing a new chain that the master link provided requires a tool you don't have and can't get on a Sunday???
i just did, so i used two pairs of vice grips to "crush" the hollow ends of the master link pins. anyone install a link like this. do ya think it is safe??
it sure looks like it, but i am still nnnervvouss
Where U at? I've got the tool if U want to use it.
go get a screw type master link. all it requires is a size 8 hex and vice grips.
Firefighters find them hot, leave them wet
If it's a race bike, I really recommend you use the compression link like you did. Others can fail, and having a chain wrap up at 100mph would be very messy for us to clean.
Definitely have someone who owns the tool and knows what they're doing, check it out and use the tool to make sure it's on there right. It is probably ok, but with something like that you don't want to guess.
actually it is on my street bike, not my track bike.
i have ridden it some, and it looks like it is good. i used a ball bearing with vice grips to further compress the pins. i wish there was a way to safety wire it.
thanks for the advise.
I bought the little tool thingy for mine...not much to it, just a couple peices of metal and some bolts that you tighten down, but if you want to use my tool and check it out, you are welcome to...that, and half the people on this site probably have the tool too.
Asshole Nazi devil moderator out to get each and every one of you
_____________________
Love Always Gene
Yikes, get the tool for that sucka, especially a press in pin set up. Now if it was a masterlink c clip style, no biggy. I've had BICYCLE chains fail on me when the pin wasn't pressed in properly before, so street or track, I'd do that thing RIGHT.
thanks for the offers to borrow.
still looks ok. still nervous about it.
i think i am just going to get another master link, cut out the original, and reinstall the new. probably get a "c" clip style and safety wire it.
Posting Permissions
Reply With Quote