Fuel line

[bodhizafa]

Is there any way to glue a plastic connector that snapped on a fuel line?????

If so what would I use to glue it?

I dropped the tank on my TE510 while trying to fix something else and I can't just by the plastic connector of course.....gotta get the entire assembly

Here are the parts.

[birchyboy]

Ooh, that's a nasty break.

I did a quick search and found a company called Up-Tite that does some rebuild work on Husky's for that problem.

http://www.thumpertalk.com/topic/750...n-2008-te-510/

http://www.uptitehusky.com/

Hope this helps.

[3point5]

no there's not…get a new one…seriously, why would you even risk something like that?

[Erratic]

Zip ties and a soldering iron. Like a plastic welding job.

[bodhizafa]

no there's not…get a new one…seriously, why would you even risk something like that?

Because Husqvarna doesn't sell the small connector and expects you to buy the entire fuel pump assembly for the small amount of $600

But I may be able to use one off another bike (Sherco Trials bike?) or one off a smaller Husky. Gonna order the parts and see if I can get them to fit, should cost about $50.......much better than the $600!