Anyone else ever painted their brakes before? On my last vehicle I painted my calipers with the G2 paint and they turned out ok. This time I opted for the VHT spray paint and I'm very happy with the results. Here are some pics and my process...

Driver's side before:


Passenger side before:



Passenger side with wheel off. Caliper is dirty and faded. Face is dark and you can barely read the logo:


Sprayed with VHT Brake Cleaner and wiped off surface dirt. Sanded with 220 grit sandpaper. Used a wire brush bit on my drill to get hard to reach places and the Brembo and Land Rover logos on the top of the caliper:


Masked off the rubber caps, brake pads and clip, and where the caliper meets the rotor with painters tape. Then stretched a trash bag over the caliper to cover the rest. Used a plastic drop cloth to mask off the wheel well and side of truck. Sprayed 3 coats of VHT primer, 10 minutes apart:


Sprayed 3 coats of VHT red, also 10 minutes between coats:



Waited 1 hour for it to dry, then added the decals:


Sprayed 3 coats of VHT clear coat, 10 minutes apart. Waited about 20 minutes then removed all masking:


All finished!


Not bad for a half days work and about $60 in supplies.