Was up at Bandi tonight. Been trying to figure out launch RPM with the new suspension setup (7" over, forks shortened internally 2") and Shinko Hook up DR. Pulled pressure down to 14psi.

Launch RPM was 10k and immediately went to WOT out of the hole. Gearing is -1/+3. I managed to cut a 1.74 60'. I think I need a tad more gearing to get out of the hole faster. SHe will be sprayed in a week or so, so im sure that will make a huge difference and I will be able to keep current gearing.


Dash vid of a 10.39 @ 136

http://www.youtube.com/watch?v=FMGJqZ5rz6k