That is true however you don't always know just how much time or frustration it takes to do something so you don't know just how valuable your time (and sanity) is

While I was typing my original message, I had a little idea. I posted the message anyway just to see if I could get replies but in the mean time I gave it a shot.

I took a wood clamp and clamped an end in the vice I have mounted to my workbench. The wood clamp's heads are just wide enough to exert pressure all around the piston.

So I put it in and a little bit at a time, I increased pressure on the clamp. When I got the top of the gasket flush with the top of the cylinder, I took a rubber mallet and whacked the trigger on the clamp until it was good and seated.

When it wouldn't go any more, I took it out and placed it on a newspaper on the workbench. A couple of whales with the rubber mallet and the piston was inside the cylinder.

It was a much harder movement but it was in place.

I put the chain cover back on and screwed the hose and the bleeder valve back in, then mounted the other bits and then bled the clutch. It started off very easily and got a little stiffer as I went along. After a few moments, the bleeder bled. Maintaining pressure, I tightened the bleeder valve. I topped off the fluid and put the cap back on it.

I started the bike and carefully shifted it into first (it was on a rear stand). It shifted smoothly. I shifted all the way up and then back to neutral. Nice smooth, if a little stiffer than before (well *duh* ).

It worked!

So I put the panels back on and took it off the bike stand (I didn't put the hump on yet; it seems every time I've dropped the bike, the hump's been on it so I don't have anything to grab).

I put the tools away, cleaned up, and shifted the bikes around to be ready for tomorrow morning's ride.

I can't wait

(I just might have to give this to the shop next time or just buy a new assembly vs putting the gasket back in. What a bear!)

Thanks for reading this and for trying to think of a solution.

Carl