I honestly do not trust myself to do it properly and I am sure some of you on here have done it before and possibly have the tools. I am willing to pay for the help since I do not have the tools to do the job and would rather have someone who knows what their doing help me out.
I am looking to chop 3 inches off of my exhaust and then would need to punch out the old rivets and then drill holes for the endcap then need a rivet gun for putting in new rivets. Once again if anyone has done this and is able to help that would be great! I am in Aurora but if anyone is fairly close by I can always remove the exhaust and drive over with it. The job does not appear to be too hard to do, perhaps an hour or so but once again I do not have the tools and do not trust myself to do it right even if I had them.
Hopefully someone can help! -Kyle