How difficult is it to set up my suspension correctly? I'm decent at working on my bike, so I could probably do it if it's not something tremendously complex.
If so, which shop would be a good place to go to do this?
I'm in Boulder, btw.
How difficult is it to set up my suspension correctly? I'm decent at working on my bike, so I could probably do it if it's not something tremendously complex.
If so, which shop would be a good place to go to do this?
I'm in Boulder, btw.
Excluding changing springs or shim stacks, it's more about understanding what you're doing than actually doing it. Doing it might at most require the use of a screwdriver and spanner. If you just set the preload, you'll probably get 80% of the benefit for 20% of the work. It's probably under Sag or Preload adjustment in your manual.
You can probably just leave the compression and rebound damping at factory settings, but if you want to get a little more involved, set the compression dampening in the front to full soft, take it for a familiar run, then full hard. Same thing with the back. Then do the extremes of rebound damping front and rear, one at a time, and you'll start to get a feel for what those things mean. Once you get a basic understanding, put all the settings back to stock (except preload), and just start playing with it given your new found understanding.
I'd suggest this book if you want to really learn about it - http://www.amazon.com/Techs-Motorcyc.../dp/0760331405
Last edited by big_sur; Mon Aug 5th, 2013 at 03:45 PM.
+1 it's more about understanding what's going on, reading the tires, and which way to turn the screws. The actual wrenching is pretty easy. It may help to have another pair or hands to use the tape measure, though. FWIW I went to Rocky Mountain Kawi in Longmont to have the guys set up my old track bike. Marv is head wrench for one of the MRA racers.
When life throws you curves, aim for the apex
Current stable: 09 Thruxton \ 09 FZ6S2 Sold List: 97 Ninja500R, 03 SV650K3, 01 Ducati 750Sport, 73 CB350/4, 03 F650GSA, 08 Gixxer600, 03 Gixxer600, 91 VFR750F, 09 KLX250, 06 Thruxton 900, 02 VFR800, 08 Spyder RS, 12 Street TripleR, 09 KLX250S, 16 KTMRC390, 10 F650GS
my Facebook, SpeedShots
+2 to what's been said already. Doing is the easy part. Understanding what to change or why the bike is doing X when you're adjusting Y is the hard part.
Go see the long-bearded one!
Let me say, the spring is by far the most important part of the equation. If you have the wrong spring, it doesn't matter what you do with any of the other settings, it's wrong.
All the other advice above is good. The "bearded one" is Dave Rose and you can find him at www.stmsuspension.com
have fun!
Dave
1998 VFR800 Interceptor - resurrected and custom tail http://vfrworld.com/forums/5th-gener...98-vfr800.html
1999 DR650SE